The Original Mevo Start Sunshade (3D Printed)

As the original creator of the fan cooled Mevo Start I have now discontinued it as the Mevo Start does NOT require fans and it is overkill and a waste of your money to spend money on a product with fans that are not needed. All it needs is the shade portion of the my design.

This is a 3D Printed piece that shades your Mevo Start from the harsh sun while including a rail of cold shoe mounting options. This will be beneficial in most areas. There is ~3mm space around the unit to allow the unit to breathe. Nothing directly sitting on the body of the Mevo Start smothering it keep heat in.

Mounts between the Mevo Start and threaded based. Do not overtighten as this is just plastic. Using washers may be beneficial to spread the tightening load.

No drilling, gluing or other modifications are required to make this attach which would otherwise void your warranty.

All shades are printed with white PETG which reflects light and doesn’t begin to soften until roughly 185 F or (85 C).

==Imperfect Finish==
These are prints that may have imperfections in the print. They are structurally sound and provide the same sun protection, but may have a couple blemishes due to plastic adhesion.
!!!!***!*!*!***!!! —--> This could be of either variation, a single or 3 cold shoe mount unit